After it is certain that the trigger guard is properly positioned and seated, it may be necessary to rap (with wood or plastic screwdriver handle) on the portion of the trigger guard behind the guard bow. If solid resistance is felt or trigger guard will not shut, check position of pawl and transfer bar. Be sure that the transfer bar is in correct position in rear of firing pin (Figure F-3). Align pawl in its recess in frame, by pulling the trigger slightly. Hook front of trigger guard into recess in frame (See Figure F-l). Note: An alternate procedure for this step is to first install the cylinder and then install the cylinder latch by pressing the forward portion of the latch against the cylinder latch plunger, until the latch is seated.Ģ. Disassembly is now complete and further disassembly is not recommended, and is not required for general cleaning and maintenance.ġ.

The cylinder latch will drop from the frame into the palm of your hand (See Figure D).ĩ. Cradle the revolver frame in your left hand and, with the thumb of your right hand, press the cylinder release button, swing out the cylinder assembly and move it forward, thus removing it from the frame. Note: If you cannot apply sufficient force (to depress the plunger) using the mainspring assembly as a 'tool', then use a screwdriver of appropriate size.Ĩ.

Simultaneously pull out and remove trigger guard assembly. Use mainspring assembly to depress trigger guard lock plunger located inside frame at rear of trigger guard (See Figure C). Lift hammer out of frame while trigger is in rearward position.ħ. Pull trigger and remove (push out) hammer pivot while holding trigger in rearward position (See Figure B).Ħ. CAUTION: Do not remove the disassembly pin until the mainspring assembly is reinstalled in the revolver at the time of reassembly.ĥ. With thumb on hammer spur, squeeze trigger allowing hammer to go fully forward. (The disassembly pin is carried in the hole in the grip panel locator.) Lacking a disassembly pin, any similar implement will serve (See Figure A).Ĥ.

Insert disassembly pin about one half its length into the hole at the lower end of the mainspring strut. Using a properly fitting screwdriver, remove grip screw and lift grip panels from frame.ģ. Be certain the revolver is unloaded and the cylinder is closed before starting disassembly.Ģ. Read instructions before disassembling gun.ġ. A loaded cylinder can discharge if dropped or struck. Never install or remove a loaded cylinder. Never clean, lubricate, disassemble or work on a revolver while it is loaded.

Ruger security six